Ford Performance 5.2L Shelby GT500 Engine Manual Control Pack
NEW FROM FORD PERFORMANCE!
Part number: M-6017-M52SC
Take the complexity and mystery out of wiring the 2020+ GT500 supercharged engine!
Designed to run M-6007-M52SC GT500 crate engine with a manual transmission
PCM with Ford Performance calibration
Electronic Throttle Control accelerator pedal, eliminating throttle cable routing problems
Unique control pack harness, which replaces the stock body harness and is designed for custom vehicle builds
OBD-II diagnostic port to assist in vehicle calibration upload and problem diagnosis
Power distribution module
Ambient Air Temperature Sensor
Clutch Position Switch
HEGO sensors (primary oxygen sensors only)
For projects locating the HEGO oxygen sensors in locations different from the production mustang locations, the PCM will need to be re-calibrated by an aftermarket dyno tuner to run properly.
PCM with Ford Performance calibration requires return type fuel system, will not work with returnless fuel system
NOTE: Installation of this PCM in a production GT500 will result in a no-start condition.
This installation setup does not include provisions for: Cruise Control, A/C, ABS, Electronic Traction Control, or OEM Anti-Theft Systems. If doing a Coyote motor swap into a production vehicle chassis for racing only with these systems, then these various systems will be turned off.
Not for use with 2007-2014 GT500 engines
Not for use with GT350 5.2L engines
